JSS Software:Diecast Forum

 You found the best diecast forum on the internet, and it is best viewed with IE 8 or greater.

Visit Automodello.
The PhillyMint
Shambles Models
ACME Trading Company.
Visit Judee Collectibiles.

Legal Disclaimer:

You must be 18 years old to post on our boards as per our registration requirement. All data posted on this site must be "Original and non defamatory". JSS is not responsible for the accuracy of any information which gets posted to our forums. Please view our Forum Guidelines before posting.

Diecast Forums 1:24, 1:18, 1:43 scales.
Diecast Forums 1:24, 1:18, 1:43 scales.
Home | Profile | Register | Active Topics | Active Polls | Members | Search | FAQ
Save Password
Forgot your Password?

 All Forums
 JSS Forums
 1:18th Die Cast Forum
 1956 Thunderbird Hardtop/Convertible
 New Topic  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  



Posted - 05/18/2018 :  12:49:27  Show Profile

Here's a new 1:18 MotorMax 1956 Ford Thunderbird Hardtop that was bought on-line. I like the model as it is photogenic in certain areas, but there appear to be a number of major factory defects/quality control problems associated with it.

When bought:

* The body looked warped and distorted, bowing up the the middle where the doors are located. Sighting down the sides of the body, this was quite apparent.

* The panel gaps around the two doors were uneven and wide, indicating such body warpage.

* The hardtop would not easily position into the body in the holes provided.

* One of the portholes in the top was missing its glass.

* The two windshield wipers were not attached properly and were loose.

* In the engine compartment, the radiator was crooked as one of the mounting tabs was fastened outside its mounting slot. Thus the radiator hose did not fit into the appropriate hole in the radiator. The two chrome exhaust pipes were out of alignment also as a result of the aforementioned non-fit.

* The hood hinge was missing its holddown and accompanying screw that anchors the holddown, making the hood flop around and extremely loose and ill-fitting.

* The driver's side rear wheel was partially cracked on the inside where it was mounted to the axle and made the wheel roll very wobbly and out of whack.

* There were various globs of spilled glue located in different areas on the model.

The model was completely dis-assembled. The flaws were corrected as best as possible, different components aligned somewhat, carpet added to the interior, paint applied to the engine and other parts, and details added here and there. It is a real shame that this particular model is shaped the way it is, either being designed this way, from being manufactured this way, damaged in transit, or some other way unbeknownst to me.

Thanks for looking....



Posted - 06/08/2018 :  10:55:54  Show Profile
Looks like it got hit in the a$$ got to bend the rear up and straighten her up a little otherwise a nice looking model.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Topic Locked
 Printer Friendly
Jump To:
Diecast Forums 1:24, 1:18, 1:43 scales. © 2000-18 Snitz Communications Go To Top Of Page
Snitz Forums 2000